Back to 9Minecraft
Wiki 9Minecraft Wiki 9Minecraft
Litematica-Printer Inprim Mod Wiki

Litematica-Printer Inprim Mod Wiki & Guide

wiki.9minecraft.net/litematica-printer-inprim-mod/

Integrates schematic printing functionality with Litematica for automated building from saved schematics.

Guides

Step-by-step, in-game.

Adjust Printing Speed and RangeAccess Configuration Settings Open the mod's configuration menu (usually accessible through the main menu or in-game…Set Up Your First Schematic for PrintingLoad a Litematica Schematic Before the printer can work, you need an active schematic loaded in Litematica. Open the…Troubleshoot Blocks Not PlacingVerify Schematic is Active Confirm that your Litematica schematic is loaded and visible in the world. Open the…Use Manual Printing ModeEnable Manual Printing Some configurations allow you to switch the printer to manual mode, where blocks only place…

Frequently asked questions

How do I start printing with this mod?
Load a schematic in Litematica, make sure it's the active schematic, then toggle the printer mode on using the configurable keybind (check your controls settings). The mod will begin placing blocks around you according to the schematic.
Why isn't the printer placing any blocks?
Check that you have an active Litematica schematic loaded and that printer mode is actually enabled. Also verify you have the required blocks in your inventory and that you're within the placement range of the schematic area.
Can I control how fast blocks are placed?
Yes, you can adjust the printing speed in the mod's configuration settings. A slower speed uses less resources and is easier to monitor, while a faster speed completes builds quicker but may cause lag.
What's the placement range and can I change it?
The placement range determines how far from your position the printer will place blocks. You can adjust this range in the mod settings to suit your needs, though larger ranges may impact performance.

See all 10 Litematica-Printer Inprim questions ›