How to Enable Vein Mining and Lumberjack Enchantments on Your Tools

Getting the Enchantments

Vein Miner adds two enchantments: Vein Miner (for ores and similar blocks) and Lumberjack (for trees). These are not applied through an anvil with enchanted books by default — the mod is command-driven, so you toggle the behavior on the tool you are holding.

Applying the Enchantment to a Tool

1. Hold the tool you want to enchant (a pickaxe for Vein Miner, an axe for Lumberjack) in your main hand.

2. Open chat and run the mod's enchant command for the relevant enchantment. The exact command syntax is listed in the commands section of the wiki — check there for the precise wording, since the mod uses command arguments rather than a GUI.

3. After running the command, the enchantment is attached to the held item. You can verify by hovering over the tool and reading its tooltip, which will list the enchantment.

4. Repeat for each tool you want to affect. Enchantments are per-item, so a fresh pickaxe will not inherit the behavior.

Using It

Once enchanted, break a single ore block or log and the mod will automatically chain-break the connected vein or tree. If nothing happens, confirm you are holding the enchanted tool and that the enchantment is still present on the tooltip.