Nuclear Control 2 Mechanics and Automation

The Monitoring Loop

To set up a basic automated safety system, follow these steps: 1. Place a Thermal Monitor against your Nuclear Reactor. 2. Set the threshold to a safe level (e.g., 2000 degrees). 3. Run a redstone wire from the Thermal Monitor to the reactor itself (or a toggle latch). When the heat hits 2000, the monitor will emit redstone, turning the reactor off. 4. Use a Remote Sensor Kit on the reactor to get a Reactor Sensor Card. 5. Place an Industrial Information Panel in your control room and insert the card. 6. If the panel is too far away, place the card in a Remote Sensor Station near the reactor and put Range Upgrades in the panel.

Energy Array Monitoring

The Energy Array Sensor Kit allows for the monitoring of up to 6 energy storage blocks simultaneously. By clicking multiple blocks with the kit before crafting the card, the Information Panel will display the aggregate energy of the entire power bank.