Using Inspirations Pipes: Setup and Routing

Crafting and Placing Pipes

Search your recipe viewer for pipe entries under the Inspirations mod. Craft the basic pipe from its listed ingredients, then place pipes block-by-block to form a run. Pipes connect to adjacent pipes automatically when placed next to each other.

Routing Items or Fluids

1. Place a source container at one end of the pipe run.

2. Place a destination container at the other end.

3. Connect the pipe line between them with no gaps.

4. Right-click pipe segments to cycle their connection mode if a side should not link.

5. Insert items or fluid into the source; the pipe moves them along the run to the destination.

Troubleshooting

• Nothing moves: a pipe segment is not connected — break and replace it, or right-click to toggle the connection.
• Wrong direction: pipes follow the run you built; rebuild the line so it terminates at the intended container.
• Leaks or spills: ensure every segment is a pipe block, not a decorative block from another mod.

Tips

Keep runs short and straight where possible. Use a single continuous line rather than branching until you understand how each junction behaves, then expand.