Enable Waterfall Particles in Your World

Check Your World Settings

Waterfall Particles runs automatically once installed, but you need to ensure the data pack is active in your world. Load your world and check that the data pack appears in your world settings.

Verify the Effect is Working

Travel to any flowing water source—a waterfall, stream, or cascade. You should see mist and spray particles appear around the water.

If you see no particles:

• Ensure you're close enough (within 20 blocks)

• Check that particles are enabled in your video settings

Troubleshoot Command Errors

If your console shows errors about command sequences, run this command in chat:

`

/gamerule max_command_sequence_length 100000

`

This increases the limit for complex commands the data pack uses. After running this, particles should display smoothly without lag or errors.