Distance From District Start

This placement preference will score zones higher if the distance between the zone site and the district start is close to a specified distance. This placement preference can be multiplied with district, buildable, and path requests.

Note

• This preference will be most reliable in low jitter bases. This is especially true if you are using smaller distances and tight tolerances with this preference.

Name

Settings

The distance (range or single value) in blocks from the district starting position that the placement should ideally be placed.

The distance from the distance_from_district_start until the score added to zones by this placement preference is reduced to 0. For the example card below, with placement preference will add 1 to the zones that are between 80-90 blocks from the district start. At 70-80 and 90-100 blocks the score added will be a value between 0 and 1 depending on how far it is from 80 and 90 blocks away.

Example

!

!

Sorry, you’ll likely need to zoom in 200% to see this one. In this example the placement preference is being used to place a district a specific distance from the village start/center. (This was used to make the screenshot below.)

!