Wiki 9Minecraft Wiki 9Minecraft
Gravity Slingshot Velocity Wiki › Guides › Troubleshooting Zipline Direction and Station Placement

Troubleshooting Zipline Direction and Station Placement

Because the Gravity Slingshot Velocity Mod relies strictly on elevation differences to function, improper height placement is the most common reason a route will not work as expected. Use these steps to fix direction issues and verify your line.

Why You Cannot Ride From a Station

If you walk up to a station block and nothing happens, you are likely standing at the lower station. Ziplines only work as downhill transport. The mod automatically designates the higher station as the start and the lower station as the destination, regardless of which block you placed down first. To ride the line, travel to the higher station and walk up to it.

Fixing Equal-Height Stations

A route requires the second station to be placed at a different height than the first. If you build two stations on completely flat ground at the exact same elevation, there is no downhill drop to power the zipline.

1. Break one of the station blocks.

2. Check the on-screen height counter while moving up or down a few blocks by pillaring up or digging down.

3. Once the indicator shows you are above or below the first station, place the second station block down again.

Finding the Zipline Path

If you lose track of where your line connects over a long distance, look for the trail of yellow particles connecting the two stations. If the yellow particle line is missing, open your vanilla Video Settings and make sure your Particles setting is set to All or Decreased rather than Minimal.