Why are some Zetta Industries blocks and items missing from creative mode or NEI/JEI?
Zetta Industries is split into individual modules that only load when their required parent mods—such as OpenComputers, Immersive Engineering, Forestry, or BuildCraft—are installed. If a parent mod is present and the feature is still missing, check your config settings to make sure that specific module is enabled.
How do you make Sulfuric Acid for the Big Battery?
Dig a one-block-deep 3x3 hole, place a Block of Sulfur in the center, and fill the eight surrounding spaces with water source blocks. Ignite the top of the Block of Sulfur with fire and wait a short time for the surrounding water to turn into eight Sulfuric Acid source blocks that you can collect.
Why isn't my Big Battery accepting or outputting any RF power?
Unlike Big Reactors where ports can go on the walls, the Big Battery requires energy input and output to be handled from the top of the multiblock using a Battery Power Tap. Also check the Big Battery GUI to make sure your energy transfer rate is configured properly.
Why isn't my Sulfuric Acid setup converting all eight blocks of water?
Every space around the Block of Sulfur must be a stationary water source block rather than flowing water. Make sure you light the very top face of the Block of Sulfur on fire and keep the fire burning until the conversion finishes.
How do I use NFC Cards for doors or computer access?
Connect an NFC Programmer to an OpenComputers system to write up to 2048 characters of data onto public or private NFC Cards. Place an NFC Reader where you want players to swipe their cards, and it will send a signal to your computer when swiped.
How does the WireGun work?
The WireGun module adds a special bullet type rather than a standalone gun item. Load these bullets into an Immersive Engineering revolver and fire them at connectors to link wires across remote or hard-to-reach locations.
How do I stop my BuildCraft quarry from causing massive fluid lag?
Set up a Quarry Fixer for your BuildCraft quarry area. It removes liquids from the dig zone and places stone along the walls to stop flowing water and lava from causing constant fluid update lag.
Can I measure RF power transfer using OpenComputers or ComputerCraft?
Yes, place an RF Meter block along your power line to measure energy flow just like a block version of the Thermal Expansion Multimeter. It integrates directly with both ComputerCraft and OpenComputers so your scripts can read the transfer rates.
How do I output an exact redstone signal strength like 7 or 12?
Use the Variable Redstone Emitter block. You can configure any of its sides independently to output a vanilla redstone signal strength anywhere from 0 to 15.
What mods work with OC Wires and the E-Catalogue?
Both require OpenComputers: OC Wires require Immersive Engineering-style connectors and wires to build overhead computer networks, while the E-Catalogue integrates with Forestry so computers can browse the trades catalogue and address envelopes.