Transfer Items Between Moving Platforms Using Rotational Power

Supply Rotational Power to the Source Connector

Item transfer requires at least 32 RPM flowing into the sending connector. Connect a rotating shaft from your Create machinery (windmill, water wheel, motor, etc.) to an Item Hose Connector or Item Magnet Hose Connector on your source platform.

Link the Connectors

For automatic linking, place an Item Magnet Hose Connector on both platforms facing each other. They'll snap together when close. For manual control, use a wrench on two Item Hose Connectors instead.

Receive Items on the Destination

Attach an item pipe or hopper to the receiving connector. Items will flow through as long as the rotational power stays above the minimum threshold and the connection is active.

Monitor Your System

If items stop moving, verify that:

• The source shaft is still spinning at 32 RPM or higher
• The connection hasn't been severed by a redstone signal
• The destination has space to receive items