This pack's saw recipes run on Create's kinetic power. The most hands-off setup connects your saw to a water wheel or windmill so it keeps cutting decorative blocks without you.
Build the Power Source
1. Choose your generator. A water wheel suits a riverside or flowing-water base. A windmill suits an open, elevated spot.
2. Build the generator and connect it to your mechanical saw through your kinetic network.
3. Confirm the saw blade is spinning before you feed it anything.
Connect the Cutting Station
1. Place your chosen Chipped design in the saw's filter slot.
2. Set up a way to keep base material flowing into the spinning blade.
3. Set up a way to collect the finished blocks so they don't pile up or despawn.
Keeping It Running
- If cutting slows or stops, check the power source first. Make sure your wheel or windmill is still turning and still connected to the saw.
- One power network can serve several stations. You could run a saw for each design you need, with each filter set to a different variant.
- Adding a station later is simple. Connect another saw to the same network and give it its own filter.
Once this is running, you can leave it working on a big batch of decorative blocks while you build elsewhere.