Inspect Bell Mounts and Button Press States

Bells and buttons are small interactive blocks that are easy to miss in a fight. This pack gives both of them clearer models.

Bell mount models

The pack provides separate bell models for floor, ceiling, and wall placements. Try each one:

1. Floor: Place a bell on top of a solid block.

2. Ceiling: Stand under an overhang and place the bell on the underside of a block so it hangs down.

3. Single wall: Place the bell on the side of a block.

4. Between walls: Build two blocks with a one-block gap between them. Place the bell inside the gap so it attaches to both sides.

Walk around each bell to see the model from several angles. Ring them to make sure you can still read the shape while they move.

Button pressed and unpressed states

1. Place a button on any solid block.

2. Look at it from the front and the side to learn its unpressed shape.

3. Press it and watch the model switch to the pushed-in state.

4. Keep watching until it pops back out.

In vanilla, wooden buttons stay pressed longer than stone ones. Place one of each next to each other to compare how long each pressed model stays visible. Knowing both shapes helps you tell at a glance whether a button near a door or trap was just used.