Tracking Redstone States and Repeater Delays Visually

Reading 3D Repeater Tick Delays

Dysfunctional’s PvP Model replaces flat redstone repeater indicators with interactive 3D geometry, allowing you to confirm circuit timings without opening debug screens.

1. Place a Redstone Repeater on any solid surface.

2. Right-click the repeater to adjust its delay setting between 1 and 4 ticks.

3. Watch the physical 3D redstone torch slide across the base plate as you click. The physical spacing of the movable torch immediately indicates the exact tick delay configured.

Checking Redstone Lines and Daylight Sensors

• Redstone Dust: Lay redstone dust along the ground. The pack provides clean edges and distinct visual states that clearly separate powered signal strength from unpowered lines.
• Daylight Detectors: Place down a Daylight Detector. The revised surface geometry and textures provide an instant visual cue showing whether the sensor is set to daylight mode or inverted night detection.
• Piston Mechanics: Hook redstone lines directly to pistons. As power passes through the circuit, the custom 3D piston head extends with clean, modern mechanical edges.