The modems are where this pack changes the most. It redesigns standard modems, full modems and the horizontal wireless modem attachment as custom 3D models with casing and antenna parts.
Placing modems to see each model
1. Set down a Computer with some open space around it.
2. Attach a standard Modem to the side of the computer. Look at it from several angles to see the 3D brass casing, not a flat panel.
3. Place a full Modem block next to your setup and compare it with the attached version. It uses its own redesigned model.
4. Attach a Wireless Modem to the side of a computer, so it sits horizontally. This shows the redesigned horizontal wireless attachment with its antenna parts.
Seeing them in action
1. Power on the computer and use the modems as you normally would in CC: Tweaked.
2. Watch the modem faces. Network components display moving texture frames when active, so a working modem should look different from an idle one.
Build tips
- Mount wireless modems on the sides of computers in a row. The horizontal antennas line up neatly along a wall.
- Pair the brass and copper modem casings with Create brass and copper blocks. Your computer room will match your factory floor.
- If a modem looks flat or wrong, check the pack's position in the Resource Packs list first.