Wiki 9Minecraft Wiki 9Minecraft
Visceral Relief Wiki › Guides › How to Move, Adjust and Reset the Bladder and Bowel HUD Meters

How to Move, Adjust and Reset the Bladder and Bowel HUD Meters

The bladder and bowel meters can be moved anywhere on screen. This helps if they overlap your hotbar, a minimap, or another mod's HUD.

Moving the Meters

Type the commands in chat.

1. Pick a screen anchor:

/pgctoilet hud anchor <anchor>

This sets which part of the screen the meters attach to. Type the command up to anchor and press Tab. The game will suggest the anchor options it accepts.

2. Fine-tune with pixel offsets:

/pgctoilet hud offset <x> <y>

This shifts the meters by exact pixel amounts from the anchor. Replace <x> and <y> with numbers.

3. Adjust in small steps. Try a small offset, check where the meters landed, and repeat until they sit where you want.

Resetting the Meters

If you push the meters off-screen or lose track of your changes, run:

/pgctoilet hud reset

This puts the meters back in their default screen location.

Tips for a Clean Setup

  • Leave the meters somewhere you can always see them. The ten-second accident countdown only starts when a meter is full, so you want to notice it climbing early.
  • If you change your GUI Scale in Video Settings, the meters may shift. Re-check their position afterward and re-run the offset command if needed.
  • Place the meters near your hunger and health bars. Then you can check all your survival needs at a glance.