How to Build a Hologram and Force Field Setup

Crafting the Emitters

Both the Hologram Emitter and the Force Field Emitter are crafted at a crafting table. Each uses a Computer Chip, a Control Circuit, and Wiring as its core. The Hologram Emitter adds Myofiber Gel for the projection medium; the Force Field Emitter adds a Solenoid to shape the field.

Wiring the Setup

Place a Charging Base as your power hub. Run Wiring from a Solar Panel to the base, then from the base to each emitter. A Control Circuit between the base and the emitters lets you switch them independently instead of running everything at once.

Projecting a Hologram

Feed the Hologram Emitter a Computer Chip programmed with the shape you want. Power it from the Charging Base. The emitter draws charge continuously while active, so keep a charged spare Computer Chip on hand to swap in without shutting the display down.

Containing With a Force Field

Mount the Force Field Emitter facing the area you want sealed. The Solenoid inside determines field strength — add a second Solenoid if the field collapses under load. Both emitters share the same power budget, so if your hologram dims when the field is up, add another Solar Panel to the array.