How to Choose and Adjust Chunk Loading Range
When setting up stationary factories across your base, you can choose between single-chunk loading with an Andesite Chunk Loader or multi-chunk coverage with a Brass Chunk Loader.
Single-Chunk Loading (Andesite)
The Andesite Chunk Loader is designed for compact setups that fit inside a single chunk.
1. Place your activated Andesite Chunk Loader directly on regular ground inside the chunk where your machines are built.
2. Supply rotational power to the block's shaft input (check the in-game Ponder guide to see the rotational requirements).
3. While active, it keeps only the single 1×1 chunk directly around the block loaded.
Multi-Chunk Loading (Brass)
If your factory spans several chunks, use a Brass Chunk Loader instead, which supports adjustable coverage areas.
1. Place the activated Brass Chunk Loader on the ground near the center of the area you want to keep running.
2. Look at the value panel on the side of the Brass Chunk Loader.
3. Scroll your mouse wheel over the value panel to switch the active loading range between 1×1, 3×3, or 5×5 chunk areas.
4. Power the loader as shown in its interactive Ponder scene. Your machines within the selected 1×1, 3×3, or 5×5 chunk grid will now continue operating smoothly even when you walk far away from your base.