Contents (3)
Place Path Blocks in a Connected Line
Connected Paths works by checking which "path-like" blocks sit next to each other, then softening the border texture where they meet. To get the effect, place your path blocks so they share full block faces rather than touching only at corners. A diagonal staircase of path blocks will still show hard edges, so step the path one block at a time and let each block share a side with the next.
Mix Your Path Materials Deliberately
Blending is strongest when the blocks you combine are all in the pack's path family — dirt, coarse dirt, dirt path, sand, gravel, and the stone variants. Lay a strip of dirt path, then run coarse dirt or gravel alongside it where you want a worn shoulder. Because the pack reads the neighbouring block, the transition happens automatically; you do not need to place any special connector block.
Check the Result From Ground Level
Fly down to eye height and walk the path. Hard edges usually appear where a block is isolated, where two path types meet at a corner, or where a non-path block (like planks or a full grass block) interrupts the run. Replace the interrupting block with a path-family block or route the path around it. If a seam still looks sharp, widen the path by one block so more faces are shared.
