RedstoneTech Shader displays redstone signal strength numbers directly on your circuits. You can see where power drops off without guessing from the brightness of the dust.
Reading signal strength on a circuit
1. Make sure the subpack with redstone signal numbers is enabled (pack settings, gear icon, slider).
2. Power your circuit, for example with a lever, a daylight detector or a comparator setup.
3. Follow the dust line and read the number shown along it. In vanilla, redstone signal ranges from 15 at the source down to 0, losing one level per block of dust.
4. Find where the number reaches 0. This is where your piston or lamp stops receiving power. Place a repeater just before that point to refresh the signal back to full strength.
5. For comparator circuits, read the number coming out of the comparator. This confirms it is outputting the strength you expect, for example from a daylight detector or a container.
Aligning builds with chunk borders
The shader also shows clear chunk borders and wireframe outlines.
- Enable the chunk border and wireframe option in the subpacks.
- Keep a whole redstone machine inside a single chunk. A circuit split across chunks can break when part of it is unloaded.
- Use the wireframe outlines to check block placement in tight, compact circuits. This makes it easier to spot a misplaced block in a dense build.