Set Up a Basic Dungeon with Entry and Exit Points

Create and Configure Your Dungeon

Start by establishing the physical boundaries of your dungeon space. Use /dungeon set pos1 <id> at one corner of your intended dungeon area, then /dungeon set pos2 <id> at the opposite corner. This defines the overall play space.

Next, designate where players spawn when they enter. Stand at your desired entry location and run /dungeon set entry <id>. This is typically near a Join NPC or dungeon entrance. Then set the exit point with /dungeon set exit <id> — this is where players are sent after completing or leaving the dungeon.

Place a Join NPC

Create a Join NPC at your entry point so players can access the dungeon through a clean interface rather than typing commands. The NPC will automatically use the entry spawn point you configured.

Test your setup by running /dungeon join <id> to verify you spawn at the correct entry location and can navigate to your exit point. Adjust positions as needed before adding rooms and encounters.