Building a Matching Drawer Wall with Biomesoplenty Woods

Choose your wood family

Every Biomesoplenty wood in the mod has the same seven-block set: Full Drawers 1, Full Drawers 2, Full Drawers 4, Half Drawers 1, Half Drawers 2, Half Drawers 4, and Trim. The available families are Dead, Fir, Hellbark, Jacaranda, Magic, Mahogany, Palm, Redwood, Umbran, and Willow. Pick one family for the whole wall so the wood grain lines up.

Lay out the wall

Start with a row of Full Drawers 4 blocks at eye level — each one holds four item types. Below them, place Full Drawers 2 or Full Drawers 1 where you want fewer, larger-capacity drawers. Use Half Drawers 4, Half Drawers 2, and Half Drawers 1 to fill gaps above or below the main rows without breaking the pattern. Cap any exposed top or side edge with the matching Trim block so the wall reads as one finished unit.

Keep it consistent

Because each family only shares its own wood texture, do not mix Fir drawers next to Redwood drawers unless you want a deliberate contrast. If you run out of one size, substitute the same family's other sizes rather than switching woods. A wall built entirely from one family — for example all Hellbark or all Jacaranda — looks intentional and makes it obvious at a glance which drawers belong to which storage system.