Linking Flux Plugs and Flux Points to a Network

Place the endpoints

A Flux Plug pulls energy out of whatever block it touches. A Flux Point pushes energy into whatever block it touches. Put a Plug on your generator or energy source, and a Point on the machine, storage block, or charger you want to feed. Both blocks must be part of the same network before any energy moves.

Assign them with the Flux Configurator

Hold the Flux Configurator and open the Flux Controller to create or select a network. Then open each Flux Plug and Flux Point individually and set its network to match the controller. Once a Plug and a Point share a network, the Plug drains its attached source and the Point delivers that energy to its attached target. You can have many Plugs and many Points on one network; all Plugs feed all Points.

Check and adjust

Open the Flux Controller to see the network's total input, output, and stored energy. If a machine is not receiving power, confirm its Flux Point is on the same network as a working Flux Plug and that the Plug's source actually contains energy. Use the Flux Configurator to move a Plug or Point to a different network, or to wipe a network's configuration entirely with the config wipe recipe if you want to start over.